Prof. Dr. Arshad Hussain Qureshi

Prof. Dr. Arshad Hussain Qureshi

PhD in 1986 from The University of New York, USA
M.Sc in 1981 from UET Lahore
B.Sc in 1971 from UET Lahore
Work Experience:
Dean Faculty of Mechanical Engineering UET Lahore
Chairman Mechanical Engineering Department UET Lahore
Professor Mechanical Engineering Department UET Lahore
Principal ICEMS

Publications

1. “The Effect of Fluid Motion and Impurities on Air Absorption and Release in Water” PhD Thesis 1986.
2. “Factors Influencing Air Absorption and Release in Water within the 1.70 atm Range”, AIAA/EPRI International Conference on Underground Pumped Hydro and Compressed Air Energy Storage, California, USA, Paper No. 82-1680.
3. “Investigation of Aerodynamic Characteristics of Aerofoils”, MSc Thesis, 1981.
4. “Bubble Growth during Decompression of Liquid”, Research Journal UET Lahore 1993 (Arshad H. Qureshi & Riaz M. Mirza).
5. “Heat Balance Integral in Steady-State Conduction”, Research Journal UET Lahore 1993 (Arshad H. Qureshi & Riaz M. Mirza).
6. “Calculation of FIN efficiency for Condensing System”, Research Journal UET Lahore 1993 (Arshad H. Qureshi & Riaz M. Mirza).
7. “Study of Angled Sprays-Measurements and Correlations”, Research Journal UET Lahore 1994 (Riaz M. Mirza & Arshad H. Qureshi).
8. “Normal Impaction of Diesel Sprays-Measurement and Correlation”, Research Journal UET Lahore 1994 (Riaz M. Mirza & Arshad H. Qureshi).
9. “Study of Normally Produced, Air-Borne Sprays-Measurements and Correlation”, Research Journal UET Lahore 1995 (Riaz M. Mirza & Arshad H. Qureshi).
10. “Characteristics of Commercial Injection System”, Research Journal UET Lahore 1995 (Riaz M. Mirza & Arshad H. Qureshi).
11. “Practical Barriers in the Way of Scientific Methodology for Realistic Energy Planning in the Developing Countries”, Technical Journal UET Taxila 2005 (M.H. Sahir & Arshad H. Qureshi).
12. “Effect of Bipolar Plates and Catalyst Materials on the Performance of Polymer Electrolyte Membrane Fuel Cells” Poster presentation in 9th grove fuel cell symposium London UK 5-9 September (2005).  (M.N. Akhtar and A.H. Qureshi).
13. “CFD Analysis of Vortex Shedding in a Circular Cylinder: Flow Induced Vibration Design” Proceeding of ICONE 14, International Conference on Nuclear Engineering July 17-20, 2006, Miami Florida, USA (Nadeem Ahmad Sheikh, M.A. Malik, Arshad H. Qureshi, M.A. Khan, S. Khushnood).
14. “Energy Modeling Applications for Analysis of Policy Options an Overview” 6th International Conference on Simulation and Modeling, Lisbon Portugal 2006, Published n Conference Proceeding September 2006 (M.H. Sahir & Arshad H. Qureshi).
15. “Energy Security and Hydropower Development Options of Pakistan WSEAS Transactions on Environmental and Development” Issue II, Volume 2, November 2006, ISSN 1740-5079.  (Mukhtar H. Sahir & Arshad H. Qureshi).
16. “Use of Energy Modeling Tools for Analysis of Policy Options”, WSEAS Transactions on Simulation and Modeling Issue 12, Vol. 5, November 2006, ISSN 1109-2777. (Mukhtar H. Sahir & Arshad H. Qureshi).
17. “Specific Concerns of Pakistan in the Context of Energy Security Issues and Geopolitics of the Region” Energy Policy, Vol. No. 35, November 4, 2007, ISSN 0301-4215. (M.H. Sahir & Arshad H. Qureshi).
18. “Modeling of Thermal Damping in Multi-Span Tube Bundle”15th International Conference on Nuclear Engineering, April 22-26, 2007 Nagoya, Japan ICONE 15-10147 (Qamar Iqbal, Arshad Qureshi et al).
19. “Prediction of Optimum Parameters for NOx Reduction using Selective Non-Catalytic Reduction (SNCR) Technique” (Thermal DeNOx Process) Pakistan Journal of Engineering & Applied Sciences, Volume 1, July 2007, ISSN 1995-1302. (M. Mansha & A. H. Qureshi and E.M Shahid).
20. “Assessment of New and Renewable Energy Resources Potential and Identification of Barriers to their Significant Utilization in Pakistan”.  Renewable and Sustainable Energy Reviews.  Volume 12, No. 1, January 2008, ISSN 1364-0321.  (Mukhtar H. Sahir & Arshad Hussain Qureshi).
21. “Molecular Sieve as an Economical Route for the Removal of Hydrogen Sulfide (H2S) & Tetrahydrothiophene (THT) from Natural Gas for Fuel Cell Application”.  The Nucleus, 45(1-2)2008: 45-53 NCLEAM, ISSN 0029-5698, (M.H. Akhtar, A.H.Qureshi and B. Guard).
22. “Effect of Temperature on Damping in Shell and Tube Heat Exchangers” 16th International Conference on Nuclear Engineering, May 11-15, 2008 Orlando, Florida ICONE 16-48251  (Qamar Iqbal, Arshad Qureshi et al).
23. “Assessment of Various Parameters of Low Temperature PEM Fuel Cell Components” Pakistan Journal of Engineering & Applied Sciences, Volume 4 (2009) 15-23, ISSN 1995-1302.  (M.N. Akhtar, A.H. Qureshi).
24. “Improvement of Porous Graphite Plate for PEM Fuel Cell by Organo-Impregnants” the Nucleus 46 1-2 (2009) 43-48, NCLEAM, ISSN 0029-5698.  (M.N. Akhtar, A.H. Qureshi).
25. “Investigation of Water Droplet Kinetics and Optimization of Channel Geometry for PEM Fuel Cell Cathodes” International Journal of Hydrogen Energy 34 7 2009, 3104-3111, ISSN 0360-3199.  (Nawaz Akhtar, Arshad Qureshi, Joachim Scholta, Christoph Harting, Matthias Messerschmidt, Werner Lehnert).
26. “One the Optimum Flow-Induced Vibration of a Tube in Heat Exchanger Tube Bundle: Analytical Modeling”17th International Conference on Nuclear Engineering, May 2009 ICONE 17-75259 (Shahab Khushnood, Arshad Qureshi et al).
27. “Importance of Added Mass and Damping in Flow-Induced Vibration Analysis of Tubes Bundle: An Overview”. Mehran University Research Journal of Engineering and Technology.  (Accepted for publication Dec. 2009) (Faisal K Shami, Arshad H Qureshi & M. Mansha)
28. Modeling and Analysis of Thermal Damping in Heat Exchanger Tube Bundles” Nuclear Engineering and Design 240 (2010) 1906-1918 (Shahab Khushnood, Arshad H. Qureshi et al).
29. “Thermal Degradation Studies and Characterization of Carbon-Polymer Composite Bipolar Plate Material for PEM Fuel Cells”. International Journal of New Carbon Materials (Submitted) (M. Nawaz Akhtar, Arshad H. Qureshi and M. Arshad).
30. “Implementation Study of Porous Graphite Plates for PEM Fuel Cell”. The NUCLEUS (In Press) (M. Nawaz Akhtar, Arshad H. Qureshi and Amad H. Qureshi).
31. Control of Combustion Generated emission from Spark Ignition Engine: A review. Pakistan General of Engineering and Applied Science. Vol. 11 July, 2012, P 114-128. (M Mansha, Ejaz. M. Shahid, and Arshad H Qureshi).
32. Simulation of Fluid Structure Interaction of Heat Exchanger Tube Using ANSYS CFX, Life Science Journal 2013; 10(2) (Abubakar Izhar, Arshad Hussain Qureshi and Shahab Khushnood).
33. Simulation of Vortex-Induced Vibrations of A Cylinder Using ANSYSCFX, China Ocean Eng. Vol. 28, No 4. pp 541-556 (Abubakar Izhar, Arshad Hussain Qureshi and Shahab Khushnood).